Catalogue

Products

Master Flash MF Square Base MF 35 Year MF Square Base Mini MF Extreme Angle MF Multi-Flash MF Multiport MF Square Vent MF Universal Retrofit MF Round Base MF Electrical Mast Connection MF Res Aluminium MF Res Lead MF Solar Flash MF Zero (Mini-Port) MF Solar Flash Multiport MF Tile Flash Solar Multiport MF MIDDY MF #2 Vent Box Gutter Expansion Joint

Master Seal

Rubber Washers

Product Flyers

Aztec News

Who's Who

Green

Install Videos

MINI-PORT MASTER FLASH® FEATURES

Accomodates:

ONE - Port 0” - 0 - 20mm (13/16” ) pipe / cable

ONE - Port 6.3 - 9.6mm (1/4“ - 3/8”) pipe / cable

Weather Protection. Made of E.P.D.M or Silicone

These flashings are compounded specifically for maximum resistance to to ozone and ultrviolet light.

Modifications Made Simple

Easy to see pipe diameters make for painless on-site installation.

Adabtable Base

SELECT and TRIM... Choose appropriate Master Flash with opening at least 20% smaller than pipe diameter. If necessary trim opening to 20% smaller than pipe diameter.
SLIDE... Slide Master Flash down over pipe. (A non-petroleum base lubricant will ease installation.)
FORM... Press Master Flash down, bending it to conform to roof profile or roof irregularities. A blunt tool will help press flashing into tight roof angles.
SEAL... Apply sealant between base and roof.
FASTEN... Use fasteners to complete sealing. For UPC installation, fastener spacing may not exceed 1-1/2" (38mm).

Mini-Port Master Flash Flashing Detail

Pipe Range	Compound	Part Number		DETAIL
0 - 49mm				A-Top Opening Diameter
(0" - 1-5/16")	Black EPDM			Closed
	Grey EPDM			B-Cut to Suit Pipe Size
	Silicone			0-20mm (0"-13/16")
PORTS	0-20mm	(0"-13/16")		C-Base Diameter
PORTS	76mm	(3" )		76mm (3")

SELECT and TRIM... Choose appropriate Master Flash with opening at least 20% smaller than pipe diameter. If necessary trim opening to 20% smaller than pipe diameter.
SLIDE... Slide Master Flash down over pipe. (A non-petroleum base lubricant will ease installation.)
FORM... Press Master Flash down, bending it to conform to roof profile or roof irregularities. A blunt tool will help press flashing into tight roof angles.
SEAL... Apply sealant between base and roof.
FASTEN... Use fasteners to complete sealing. For UPC installation, fastener spacing may not exceed 1-1/2" (38mm).